Abnormal installation of DVR software
The first one is resolution mistakes while installing. The quality of color in display devices must be adapted to 32 pixels and the resolution with 1280*1024 or 1024*728. Secondly, the file for drive and hardware cannot be found. As is often the case that software can support and analog hybirds. You need to turn down your personal computer, unplug the card and clean it of change a slot to install.
No image displayed
At first, your should check the operation of power. Under the normal condition, the red indicator would be always lighting on the back of wireless network. POE IP Camera can work well on conditin that PDVR and POE switchs could be empolyed simutaniously and connect ordinary personal computer to DV12 power. Then, check the network, if fixed IP used, the local area network of personal computer must be in accordance with that of camera. In normal condition, the yellow indicator should be lighting and green indicator twinkling. Thirdly, check the configuration of software of ip camera and whether the len cap is open or not. IPs for each of them differ for your adoption of local area network.
At first, your should check the operation of power. Under the normal condition, the red indicator would be always lighting on the back of wireless ip camera. POE of camera can work well on conditin that PDVR and POE switchs could be empolyed simutaniously and connect ordinary personal computer to DV12 power. Then, check the network, if fixed IP used, the local area network of personal computer must be in accordance with that of camera. In normal condition, the yellow indicator should be lighting and green indicator twinkling. Thirdly, check the configuration of software of IP camera and whether the len cap is open or not. IPs for each of them differ for your adoption of local area network.
Abnormal images displayed
Unclear images. You are expected to use hundreds of solutions len and better effect would be given. Check the focus length and adapt it untill clear images displayed. Moreover, discontinuous images and the images easily get stuck. In this case, you need to check the condition of resources used and CPU/RAM occupied.
Alteration of IP of ip wireless camera. At first, we can change IP only when they are connected and images displayed. It is usual that there is no image after changing IP. It would come into effect after restarting the software. Another case is that you forget IP after alteration. You should reset the wireless network with the reset button pressed for 10 seconds. If it doesn`t work, you need to send it to the factory for repair.